/*
  Software serial multiple serial test

 Receives from the hardware serial, sends to software serial.
 Receives from software serial, sends to hardware serial.

 The circuit:
 * RX is digital pin 2 (P0_10) (connect to TX of other device)
 * TX is digital pin 6 (P0_2) (connect to RX of other device)

 Note:
 Not all pins on the Elbear Ace-Uno/Ace-Nano support interrupts,
 so only the following can be used for RX: 2, 3, 4, 5, 8, 9
 Elsomik board pins with interrupts: P0_8, P1_4, P1_5, P1_6, P1_9, P1_10, P1_15, P2_7
 Start board pins with interrupts: P0_10, P0_12, P0_13, P0_14, P0_15, P1_9, P1_15

 created back in the mists of time
 modified 25 May 2012
 by Tom Igoe
 based on Mikal Hart's example

 This example code is in the public domain.

 */
#include <SoftwareSerial.h>
int rx_pin = 2; // P1_9 for Start/Elsomik
int tx_pin = 6; // P0_2 for Start/Elsomik
SoftwareSerial mySerial(rx_pin, tx_pin); 

void setup() {
  // Open serial communications and wait for port to open:
  Serial.begin(115200);
  while (!Serial) ; // wait for serial port to connect. Needed for native USB port only
  Serial.println("Goodnight moon!");

  // set the data rate for the SoftwareSerial port
  mySerial.begin(9600);
  mySerial.println("Hello, world?");
}

void loop() { // run over and over
  while (mySerial.available()) 
    Serial.write(mySerial.read());
  
  while (Serial.available()) 
    mySerial.write(Serial.read());
  
  delay(50);
}