добавлены комментарии по выбору пинов для разных плат. Для стартовых примеров добавлен ifdef для автоматического задания корректных выводов

libraries/SoftwareSerial/examples/SoftwareSerialExample/SoftwareSerialExample.ino

@@ -5,13 +5,14 @@
  Receives from software serial, sends to hardware serial.
 
  The circuit:
- * RX is digital pin 2 (connect to TX of other device)
- * TX is digital pin 6 (connect to RX of other device)
+ * RX is digital pin 2 (P0_10) (connect to TX of other device)
+ * TX is digital pin 6 (P0_2) (connect to RX of other device)
 
  Note:
- Not all pins on the Elbear Ace-Uno support interrupts,
- so only the following can be used for RX:
- 2, 3, 4, 5, 8, 9
+ Not all pins on the Elbear Ace-Uno/Ace-Nano support interrupts,
+ so only the following can be used for RX: 2, 3, 4, 5, 8, 9
+ Elsomik board pins with interrupts: P0_8, P1_4, P1_5, P1_6, P1_9, P1_10, P1_15, P2_7
+ Start board pins with interrupts: P0_10, P0_12, P0_13, P0_14, P0_15, P1_9, P1_15
 
  created back in the mists of time
  modified 25 May 2012
@@ -22,8 +23,9 @@
 
  */
 #include <SoftwareSerial.h>
-
-SoftwareSerial mySerial(2, 6); // RX, TX
+int rx_pin = 2; // P1_9 for Start/Elsomik
+int tx_pin = 6; // P0_2 for Start/Elsomik
+SoftwareSerial mySerial(rx_pin, tx_pin); 
 
 void setup() {
   // Open serial communications and wait for port to open: